So you have just unwrapped a TN-360 toner your purchased a handful of months back, to replace your printer’s cartridge which is now blinking empty. Following diligently following the manufacturer’s installation directions, you notice that the LED light on your Brother Laser Printer’s manage panel continues to flash. Then you comprehend that it really is 12midnight, and you happen to be rendered virtually helpless, as you have definitely no clue how to acquire a replacement toner in order to print an 80 page report that is due 1st issue in the morning.
When such instances happen, a single may possibly instinctively get in touch with a technician for diagnosis, or get a new toner to replace what’s presumably a faulty cartridge. Although these troubles are not uncommon, it really is excellent to know that most of these troubles can be rectified with out getting to consult a specialist. Whether you have bought a genuine toner or an aftermarket cartridge, here’s a list of troubleshooting directions for some TN-360 installation issues:
1. Your printer’s LED light blinks constantly even right after replacing the TN-360 toner and DR-360 drum.
There will be certain instances when you could need to manually reset your printer to remove a blinking LED drum light. 1st, you’ll have to open your printer’s front cover. With your new drum and toner nevertheless installed, press the go button or the white button. Hold for about four seconds until your printer’s entire manage panel lights up. Close the front cover and your printer ought to now be ready for use.
2. Your newly replaced laser toner cartridge is prematurely displaying as empty
If your printer’s handle panel indicates an empty cartridge and you’re virtually particular (based on preceding prints) that your toner is nowhere near empty, this easy trick should enable you to extend your toner’s mileage. Start by pulling out your cartridge from your printer. You need to see two holes at each side http://www.ebay.com/sch/i.html?_nkw=Printer+Ink of your toner. Use an electrical tape to cover both holes and reinsert your toner cartridge. You ought to be capable to print a couple of hundred more pages and save dollars without getting to replace your TN-360 toner.
three. Flashing Error Light
A flashing error light can be one of the easiest but sometimes also the most challenging of errors to troubleshoot. If you’ve just installed a new TN-360 cartridge, there might be a need to have to clear your printer’s memory which by now is very possibly complete. Reset your printer by pressing the go button and holding it for around five seconds. Turn your printer off and on to verify.
If the error persists, verify for any paper jam. Inspect both the front and back panels. Don’t neglect to pull out the DR-360 drum. Most paper jams occur in toner tn360 the drum and rear panel locations. Torn label and tape can lead to severe errors and are typically challenging to detect so make sure your printer is clear of any debris.
These are basic troubleshooting ideas that will aid you diagnose or repair some issues which you may well have with your toner or printer. If you continue to knowledge concerns, do not try to discover any further as this might trigger further damage. When in doubt, don’t hesitate to contact a certified printer technician.